Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

pix 501 ver 7.01 uptime not update

Hi All,

We are using Cisco PIX Version 7.0(1)

Device Manager Version 5.0(1)

checking pix uptime using the show version command

it's display up 49 days 17 hours, stuck on it and does not update

any advice will be appreciate

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: pix 501 ver 7.01 uptime not update

hi ..

1.- downlaod the file to a system and taht has TFTP application

2.- As always make a backup copy of your config

copy running-config tftp

3.- from the command line on the PIX type in

copy tftp flash .. and follow the prompts.

4.- when image has been downloaded then use the boot system command to indicate which image should be used when the system reloads.

boot system flash:/

4.- reload the PIX

I hope it helps ... please rate it if it does !!!

5 REPLIES
New Member

Re: pix 501 ver 7.01 uptime not update

Hello !

There is a bug issue related to your problem that was discovered on FWSM.See bug CSCei20682 FWSM uptime stops at 49 days 17 hours.

According to the release notes this problem is solved on version 7.0(4).

Check this document

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_70/70_rn/pix704rn.htm

Hope this helps ! rate if it does ...

New Member

Re: pix 501 ver 7.01 uptime not update

Thanks for your response.

Is there any document for upgrade the pix version from 7.01 to 7.04 ?

Thanks

Re: pix 501 ver 7.01 uptime not update

hi ..

1.- downlaod the file to a system and taht has TFTP application

2.- As always make a backup copy of your config

copy running-config tftp

3.- from the command line on the PIX type in

copy tftp flash .. and follow the prompts.

4.- when image has been downloaded then use the boot system command to indicate which image should be used when the system reloads.

boot system flash:/

4.- reload the PIX

I hope it helps ... please rate it if it does !!!

New Member

Re: pix 501 ver 7.01 uptime not update

Thanks Fernando

exactly what i was need.

your are wonderfull

Re: pix 501 ver 7.01 uptime not update

cheers ... more than happy to helps if I can

355
Views
3
Helpful
5
Replies