11-16-2003 08:33 AM - edited 02-20-2020 11:06 PM
Dear readers,
I have ADSL + static single IP.
Instead of using linux firewall, I would like to use my PIX 506. My HTTP server is at inside at 10.1.1.100.
When configuring static to map outside interface address to port 80 at 10.1.1.100 I receive error message saying "ip address is already used on outside interface, can't specify translation rule for it".
Does this mean I need at least 2 global addresses, one for the outside interface, the other for the http internal server to become reachable ?
11-16-2003 01:01 PM
Hi,
You need a statement like this
static (inside,outside) tcp interface 23 10.101.1.1 23 netmask 255.255.255.255
Thanks
Nadeem
11-17-2003 12:57 AM
Thanks Nadeem.
It works. I wasn't aware of this second syntax of the static command, which was not listed in my cisco pix book.
Appreciate your quick reply on this.
regards,
diederik
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: