Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX 506 Firewall w 6.22

am new at this.

Is it possible to configure a Pix at one location between 2 sites? Allowing the other location to be trusted. Are there issues? If possible, what is the best config setup for this type of situation?

For example - I have an office A with a PDC and 30 users with PIX 506 connected by a router from ISP. The other side Office B has a BDC with 5 users and a router. Our ISP points this router from Office B to A. At one point the ISP handled NAT between both offices.

1 REPLY
Silver

Re: PIX 506 Firewall w 6.22

Hi,

You can configure pix in one of the locations and trust the other location.

This is a common practice....no other configuration needed.

80
Views
0
Helpful
1
Replies