Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix 506 Full Duplex

When I try to create my DMZ by placing an 8 port hub between my PIX 506 and Cisco 2600 series router I cannot get the PIX to link up. I thought I read something indicating that the 506 was set to auto-negotiate and was capable of Half Duplex communication. I havent tried to put a switch between the PIX and the Router to see if it gives me a link but even if it did I would not want to waste a switch to create my DMZ. Any suggestions?

1 REPLY
New Member

Re: Pix 506 Full Duplex

I would manually configure the interfaces on the Router and the PIX to 10Mbps half-duplex. If this does not work I would check the cables. If it works I would then incresase the speed to 10 Mbps/Full duplex, and so on. But I do not agree with you not to use a switch to create the DMZ.

Good luck

Goran

107
Views
0
Helpful
1
Replies
CreatePlease login to create content