Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 506e in Single Armed Mode

I amtrying to know that can i use pix 506e in single armed mode.

I have to place a pix and the only solution to it is this only

Thanks

Chetan

3 REPLIES

Re: PIX 506e in Single Armed Mode

Hello,

When you say single armed mode I'm assuming that you mean a router on a stick where all the traffic comes to and leaves out of a single interface. If this is what your wanting to do then no a 506e with 6.x and below does not have the ability to let traffic that has arrived on an interface leave the same interface.

Patrick

Please rate any posts that are helpful.

Re: PIX 506e in Single Armed Mode

Hello,

When you say single armed mode I'm assuming that you mean a router on a stick where all the traffic comes to and leaves out of a single interface. If this is what your wanting to do then no a 506e with 6.x and below does not have the ability to let traffic that has arrived on an interface leave the same interface.

Patrick

Please rate any posts that are helpful.

New Member

Re: PIX 506e in Single Armed Mode

I see no Reason to to this unless u absolutly have only one interface available on your switch.

since release 6.3.(4) u are able to configure 1 extra vlan interface on the 506e.

so u could trunk the switch with the pix en firewall between the two vlans.

Troughput for both vlans is ofcourse Limited by the fysical interface.

107
Views
0
Helpful
3
Replies
CreatePlease login to create content