This is a very basic question, but this is my first time setting up a VPN and do not know where to start.
Can someone tell me what is the best way to go about setting up a VPN. I have a PIX 506E, my internal network consists of two W2K servers and a few clients. The main reason for this VPN is to allow my remote users to have access to the network and replicate their e-mail (Exchange)
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...