Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

PIX 506e w/Cisco VPN client almost works except for...

We are temporarily using a PIX 506e to terminate VPN connections. We have set up the PIX to allow our administrators to use the Cisco VPN client to land directly on the interior of our LAN. Every application works (Outlook, all admin tools, etc) with the exception of one tool, Funk Proxy. It's a remote control app that we use to control all servers and PC's on our network. The app can poll all clients on the network and that part works fine. But when you attempt to connect to a machine it prompts for the password as it should and then connects. But it will only paint a few lines of the desktop then stop. After about ~20 seconds it errors out saying the client ended the connection. We currently use this Funk Proxy app with a Nortel Contivity VPN and it works fine.

Any ideas what on the PIX could be causing this problem?

Thanks

2 REPLIES
New Member

Re: PIX 506e w/Cisco VPN client almost works except for...

i can not say what the issue is here but it would be good to get some debugs:

debug crypto ipsec

debug crypto isakmp

this would help you to solve this. post any helpful debugs and we might be able to help

sam

New Member

Re: PIX 506e w/Cisco VPN client almost works except for...

207
Views
0
Helpful
2
Replies
CreatePlease to create content