Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

pix 506e will not boot

I have a pix 506e that will not boot past the point noted below where I have pasted the console screen output. All testing that I can do up to that point comes out ok. Any help with this problem?

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

32 MB RAM

PCI Device Table.

Bus Dev Func VendID DevID Class

00 00 00 8086 7192 Host Bridge

00 07 00 8086 7110 ISA Bridge

00 07 01 8086 7111 IDE Controller

00 07 02 8086 7112 Serial Bus 9

00 07 03 8086 7113 PCI Bridge

00 0D 00 8086 1209 Ethernet 11

00 0E 00 8086 1209 Ethernet 10

It will stop at this point and is unresponsive.

Thanks

4 REPLIES
New Member

Re: pix 506e will not boot

Hello. I am having exactly the same issue all of a suddent. No changes have been made to this device. If I hit "ESC" upon power up, I can run some basic diagnostics and all tests pass. It just hangs the same way.

New Member

Re: pix 506e will not boot

Thanks for your reply. I am wondering if using pdm has anything to do with it. Did you use the web inteface pdm to program your pix?

New Member

Re: pix 506e will not boot

Hi.

No. I did everything manually.

I spoke w/ Cisco today and they said that this is a hardware failure and the only resolution is to RMA the unit :(

Let me know if you hear otherwise.

Thanks,

Shawn

New Member

Re: pix 506e will not boot

Hi, i have the same problem. Can you solve it jumper the bios, the jumper is near the battery.

The real problem is it will pass again !!!

i can?t find a cisco solution : (

bye.

177
Views
0
Helpful
4
Replies