Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX 515 and Load Balancing

Hi,

anyone can confirm that PIX 515 support for Load Balancing... so there ada two default route to the different gateway ip address ??

thanks

1 REPLY
Silver

Re: PIX 515 and Load Balancing

Stateful packet filtering requires that BOTH inbound and outbound packets transverse the same PIX. You can use two PIX’s in failover mode to eliminate a single point of failure but you’ll have to do any and all load balancing on the outside of the PIX.

98
Views
0
Helpful
1
Replies