Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 515 DMZ Configuration

i am not sure what is causing this problem. I have a PIX 515 with Three Interfaces. I can communicate between the inside and the outside, but have no way of communicating between the inside and the DMZ or the outside and the DMZ as if my DMZ interface is down, I know it is up since I can ping servers on that side only from the DMZ interface.

Am I missing a route statment somwhere ??

Any suggestions are greatly appreciated

1 REPLY
New Member

Re: PIX 515 DMZ Configuration

Adam,

Could you provide us with the nat, global, static and access-list (or conduit) commands? You can replace real addresses with fake addresses.

134
Views
0
Helpful
1
Replies