Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

PIX 515 Multiple Subnet NAT

My customer has 3 public networks and a single Internet connection. The IP address space on their Internet connection is a 30 bit point to point subnet. The other 2 networks are Class C. They want to use these 2 Class C networks for Static nat translations to inside hosts that are using private addresses.

I have tested this with a router using secondary addresses for each of the class C networks on the outside interface and it works.

I need to know if this will work on the pix.

Thanks,

Kevin

1 REPLY
New Member

Re: PIX 515 Multiple Subnet NAT

That will work with the Pix just fine. Just set the route for the 2 public class C's from the router to the Outside interface of the Pix. The outside interface of the Pix would use and address from the 30 bit point to point subnet. Then make your static translations and you're all set.

95
Views
0
Helpful
1
Replies
CreatePlease to create content