I'm in the process of writing a config for our PIX 515 that will allow telecommuters to work from home using PcAnywhere. We had a previous config on our router that did what we needed, but now that I'm putting a PIX in between the router and the internal network, I am kind of stumped. I'll reply to this post with the PIX config since this is too long. Here is the NAT portion of our current router config that has been working for years:
ip address 216.x.x.x 255.255.255.224
ip nat outside
ip address 10.0.0.1 255.0.0.0
ip nat inside
ip nat pool HCDM 216.x.x.x 216.x.x.x netmask 255.255.255.224
ip nat inside source list 101 interface Ethernet0/0 overload
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...