Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

PIX 515 Reset to factory default

We just purchased a PIX 515 - no floppy disk. I know the procedure to perform the password recovery i.e. using tftp method but have no idea what the internal ip address is in order to execute the monitor > . Any other options/solution?

Thanks.. Jacky

1 REPLY
Community Member

Re: PIX 515 Reset to factory default

Use the address command to specify the IP address of the PIX Firewalls interface when in RomMon mode. Check the steps here: http://www.cisco.com/univercd/cc/td/doc/cisintwk/itg_v1/tr1925.htm#xtocid1622518

846
Views
0
Helpful
1
Replies
CreatePlease to create content