I have a public ip address, and have a sprint dsl. When the dsl was first installed the rep set the sprint router up with one of my public ip addresses so the workstations could access the internet. That works fine. Now i am trying to install a pix 515 between the sprint router and my network. But no luck.
I get access to the internet with a dynamic ip assignment from my isp. And sprint told me to assign the router 192.168.1.1, assign the outside port of the pix 192.168.1.2.
Pls look at config, and, someone said something about bridging the router and configure PPPoE on the pix to send the username and password to the get access to the internet???????? HELP
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...