I currently have out PIX configured to have 3 of our locations terminating to it. What I am trying to figure out is if you can allow all of the locations to access the internet without using split tunnel?
Currently I am having a ahrd time grasping how it can be done.
While using Client to PIX IPSec VPN, split tunneling is the only way that I know of to tell the client what traffic should be sent out encrypted and what traffic could be put out directly to the internet without encryption. I do not think you can do without split tunneling. However, if you do find a way, would it be possible for you to share it through the forum.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...