Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX 515 with smtp

Dear

I am beginner of PIX

I set up a network

Internet ----PIX--- mailserver and DNS

And I run the following command

conduit permit udp DNS eq 53 any

conduit permit udp mailserver eq smtp any

I can resolve the MX and IP of mailserver in internet zone.

When I send mail to mailserver from internet, it can't delivery.

So I telnet mailserver with port smtp

The connection is ok but after 1 second the connection is dropped.

DO u have any idea of this problem

Thank you

  • Other Security Subjects
3 REPLIES
Cisco Employee

Re: PIX 515 with smtp

Check your config against:

http://www.cisco.com/warp/customer/110/mailserver_in.html

The turn on logging to troubleshoot with:

logging buffered debugging, then do a show log to

see who is sending the reset. You might want to do

a clear log before doing the tests.

New Member

Re: PIX 515 with smtp

conduit permit udp mailserver eq smtp any

should be:

conduit permit tcp mailserver eq smtp any

smtp is over TCP. hope this helps

New Member

Re: PIX 515 with smtp

SMTP uses TCP ...

93
Views
0
Helpful
3
Replies