My PIX 515 is the end point to several remote offices with 501s and 506s. All offices except one have a static IP address and work fine. I'm having trouble bringing up the one site (506) with a dynamic address provided via cable modem. The PIX 506 is acting as a DHCP client and server and this too is working well. I've tried using the crypto dynamic-map commands on the 515 but have been unsuccessful. I believe the 506 should be configured normally with the 515 as its peer. Could someone provide the proper commands for the 506?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...