Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

pix 515 won't boot

OK, I think I've screwed up. I have a PIX 515 with what I think is 6.3(3) code and I've accidentally used the np44.bin to reset the password.

The seemed to work OK for a minute, then the PIX would not boot. After a power cycle nothing displays in HyperTerm and I get a flashing Network light only (no power or act). Is there some jumper that could be reset, etc...? Any other suggestions?

Thanks.

  • Other Security Subjects
120
Views
0
Helpful
0
Replies