06-15-2006 08:39 AM - edited 02-21-2020 12:58 AM
hi all,
I recently deleted one of my nat statements because i needed to change the address the inside was being natted to. well i removed the old and added a new. i see it in the running config. but when i ping from the outside world, the old address still answers and the new one does not. am i missing something?!
TIA,
R
06-15-2006 02:20 PM
Hello,
Could you try to:
clear xlate
"After you make any changes to translation rules on the PIX it is strongly encouraged that the clear xlate command be issued. This ensures that any old translations do not interfere with newly configured ones and cause them to operate incorrectly."
Please rate this post if this helps.
Vlad
06-19-2006 01:04 AM
Do keep in mind an clear xlate clears all translations thus dropping all active connections which are translated.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: