09-05-2006 09:22 AM - edited 02-21-2020 01:09 AM
I would like to replace my 2 port ethernet module with a 4 port module. Is this just a straight forward hardware install? How do you activate the new ports? We have a ur license. Thank You.
Solved! Go to Solution.
09-05-2006 11:26 AM
Just power-off the box, remove the old card and slot in the new quad card.
After you power-on the box, you need to activate/key-in the activation key @ license, and reboot the box. You should be able to see the new 4-ports. Active/configure it like your other/previous ethernet ports.
pixfirewall(config)#activation-key
Make sure you backup your config as well.
Rgds,
AK
09-05-2006 11:26 AM
Just power-off the box, remove the old card and slot in the new quad card.
After you power-on the box, you need to activate/key-in the activation key @ license, and reboot the box. You should be able to see the new 4-ports. Active/configure it like your other/previous ethernet ports.
pixfirewall(config)#activation-key
Make sure you backup your config as well.
Rgds,
AK
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: