PIX 515E license - restricted or unrestricted??

[jeff.vargas]

How can I tell which license I have on a PIX515E? I need to know if it is restricted or unresticted. Here's the output of sh ver but nothing jumps out at me and says which one.

Cisco PIX Firewall Version 6.2(2)

Cisco PIX Device Manager Version 1.1(2)

Compiled on Fri 07-Jun-02 17:49 by morlee

EAC-FW01 up 3 hours 24 mins

Hardware: PIX-515E, 32 MB RAM, CPU Pentium II 433 MHz

Flash E28F128J3 @ 0x300, 16MB

BIOS Flash AM29F400B @ 0xfffd8000, 32KB

0: ethernet0: address is 000a.b7bc.4b30, irq 10

1: ethernet1: address is 000a.b7bc.4b31, irq 11

2: ethernet2: address is 0002.b3ad.8176, irq 11

Licensed Features:

Failover: Enabled

VPN-DES: Enabled

VPN-3DES: Disabled

Maximum Interfaces: 6

Cut-through Proxy: Enabled

Guards: Enabled

URL-filtering: Enabled

Inside Hosts: Unlimited

Throughput: Unlimited

IKE peers: Unlimited

Serial Number: 806343913 (0x300fd4e9)

Running Activation Key: xxxx

Configuration last modified by enable_15 at 10:26:27.064 UTC Tue Feb 7 2006

[stomasko · Accepted solution]

This is an unrestricted license. The number of maximum interfaces is one way to tell. Restricted is only 3 where UR is 6. You can use this page to see other differences.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_data_sheet09186a00800b0d85.html

You could also paste your show version into Output interpreter tool if you are a registerd user.

Steve

[dgloff]

Another way to tell is Failover is enabled. Failover is not supported in the Restricted license.