Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

PIX 515E to ASA5510 conversion

I currently have a 515E PIX and I just purchased a ASA5510 box. Can I cut and paste the running configuration statements from the 515 into the ASA5510. The 515 is running version 6.3 and the 5510 is running 7.02? Thank you for your time!

  • Other Security Subjects
3 REPLIES
New Member

Re: PIX 515E to ASA5510 conversion

hi first of all there are moajor command line changes in the new ios which the asa uses . it will convert all fixup commands to MPF commands and so . but while converting aaa commands it might not do ir right same goes with the vpn. it's better u reconfigure the new ios . it's easy incase u have any doubts in configuring write back .hope this helps

sebastan

Re: PIX 515E to ASA5510 conversion

Hello,

I've upgraded four pix 515's to the 7.0 code. I have not had issues except for a small amount of clean up.

Patrick

Gold

Re: PIX 515E to ASA5510 conversion

the codes are quite different, thus copy and paste directly from pix v6.x to asa will not work.

assuming you prefer not to manually play with the codes. you can upgrade the pix to v7, and part of the upgrade is to modify the codes to suit v7 automatically.

you may even test the new config with pix making sure it works, then copy and paste from pix v7 to asa.

112
Views
0
Helpful
3
Replies