Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 515R PDM ACCESS ON OUT SIDE INTERFACE

Greeting to all ,

Can any one give me config for PDM access to one specific ip address out side interface of firewall

3 REPLIES
Cisco Employee

Re: PIX 515R PDM ACCESS ON OUT SIDE INTERFACE

Run the "setup" command to establish the public/private key pair and it'll also ask you for the location of the machine running PDM. Enter in this IP address.

If that doesn't work, then the command is simply:

> http server enable

> http x.x.x.x 255.255.255.255 outside

where x.x.x.x is the outside machine's IP address

New Member

Re: PIX 515R PDM ACCESS ON OUT SIDE INTERFACE

great,but if i'm a teleworker conneting using VPN client and hooking up to the internet with fixed IP address.what is the config

Cisco Employee

Re: PIX 515R PDM ACCESS ON OUT SIDE INTERFACE

Then you need to connect ot the inside interface of the PIX, so upgrade it to 6.3 and use the following command:

> management-access inside

Then allow the VPN pool of addresses to http to the inside interface, should get you going.

See http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/mr.htm#1137951 for details of the new command.

151
Views
0
Helpful
3
Replies