I attempted to load IOS 6.2.2 on a PIX 520 firewall. I was incredibly unsuccessful and violated my change window immensely. Essentially the software was not doing any PAT or NAT translation. I cleared all my configs and wrote only the NAT/PAT configurations and even that did not work. To resolve I rolled back to my previous IOS and used the same few configurations with easy success. I do understand that 6.2.2 is ED, but I never seen such disaster. Just FYI.
I'm not sure that the problem was with NAT. It is possible that NAT coupled with some other command might have caused this. I just saw a couple of configuration, tested on 6.2.2 all of which were using NAT. All the same, it's never a good idea to use anything but General deployment versions in critical production networks, especially on firewalls where security might be compromised due to unknown loopholes.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...