Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 520 IPSec VPN Tunnel to a Netgear FVS318

Does anyone have any sample configs or tips on connecting an IPSec VPN Tunnel (3DES) from a PIX 520 (6.2(2)) to a Netgear FVS318? The tunnel comes up when traffic is initiated from the Netgear end, but not when I initiate traffic from my internal network.

5 REPLIES
Bronze

Re: PIX 520 IPSec VPN Tunnel to a Netgear FVS318

Hi Jrichv,

Unfortunately, there is no sample configuration at Cisco's web-site to configure a pix firewall and a NetGear device. It will be nice to collect the "debug crypto isakmp and debug crypto ipsec " on the pix firewall and then initiate a session. The debugs will help in isolating the issue

Hope that helps

Jazib

New Member

Re: PIX 520 IPSec VPN Tunnel to a Netgear FVS318

I am remotely connected to my PIX, and even though I have the "debug crypto: ipsec and isakmp" turned on, I am not getting debug messages. Yes, I have typed in "terminal monitor", but to no avail.

Bronze

Re: PIX 520 IPSec VPN Tunnel to a Netgear FVS318

Hi,

Pix firewall sends debug messages to only one session. Make sure that you don't have any telnet or any other SSH sessions opened to a pix.

Hope it helps

Jazib

New Member

Re: PIX 520 IPSec VPN Tunnel to a Netgear FVS318

I am the only one logged in... I verified this, but it still doesn't work. It is in a remote data center, miles away, and its not practical to go to that site.

Richard

New Member

Re: PIX 520 IPSec VPN Tunnel to a Netgear FVS318

Hi,

does the connection work now? I have still the problem to establish the connection. Is it possible to mail me your configuration? In case of security problems let your Ip´s away from the config.

sk4711@yahoo.de

Please, please... thanks a lot,

Sebastian

245
Views
0
Helpful
5
Replies