Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix 520 trouble getting H323 mapped

I have a Pix 520 PIX Version 4.2(4) and have been trying to map and inside address to an outside address for my Polycoms these are the lines I used but they don't work.

static (inside,outside) 128.171.188.1 10.1.4.52 netmask 255.255.255.255 0 0

conduit permit tcp host 128.171.188.1 any

conduit permit udp host 128.171.188.1 any

I tried using the H323 command that did not work this same configuretion runs on one of my other firewalls the only difference is the PIX Version 4.4(1)

Am I missing something or is this simply a version problem.

Thanks

1 REPLY
New Member

Re: Pix 520 trouble getting H323 mapped

Yes it’s a version issue. I don’t remember the version they started supporting h.323 but I was thinking you had to be on 5.x something.

130
Views
0
Helpful
1
Replies
CreatePlease to create content