I am wanting to setup a site to site VPN between to locations. One site uses 10.10.3.0 - 255.255.255.0 and the other one uses 10.10.9.0 - 255.255.255.0. I am trying to use the VPN wizard, but appear to be doing something wrong on the last two pages where it asks for the local and report address ranges. Help!!!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...