I'm trying to use two PIX 525s in a failover configuration. But failover box is always in the "failed" state. There's no problem with physical connections (both ethernet and failover ). I'm restarting the fdailover box, issuying "failover reset" command on the primary PIX but it's no use. How can I get out of this "failed" state?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...