Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Pix 525 hardware problem?

hello

when powered on the pix will display the following message and then stop booting up:

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

256 MB RAM

PCI Device Table.

Bus Dev Func VendID DevID Class Irq

00 00 00 8086 7192 Host Bridge

00 07 00 8086 7110 ISA Bridge

00 07 01 8086 7111 IDE Controller

00 07 02 8086 7112 Serial Bus 9

00 07 03 8086 7113 PCI Bridge

00 0D 00 8086 1209 Ethernet 11

00 0E 00 8086 1209 Ethernet 10

00 11 00 11D4 2F44 Unknown Device 11

what could be the issue? how to solve the problem?

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Pix 525 hardware problem?

Hello,

Open the PIX and inside you will find a battery. Remove the battery for few seconds and of course remove the power plug.

After that insert the battery again and power on and you should be UP.

PLease rate this post if solves your problem,

Regards,

2 REPLIES
Silver

Re: Pix 525 hardware problem?

Hello,

Open the PIX and inside you will find a battery. Remove the battery for few seconds and of course remove the power plug.

After that insert the battery again and power on and you should be UP.

PLease rate this post if solves your problem,

Regards,

New Member

Re: Pix 525 hardware problem?

Hi,

I've had the same problem last week.

Opening a RMA was the only solution.

Kr.

Robby

98
Views
0
Helpful
2
Replies
CreatePlease to create content