Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

PIX 525 Ver. 6.3(1) & static IP problems

I'm having problems changing static IP addresses to internal IP addresses.

The original statement looked like this,

static (DMZ,outside) xxx.xxx.46.3 192.168.1.2 netmask 255.255.255.255 0 0

When I change the external ip address to point to another internal IP address,

static (DMZ,outside) xxx.xxx.46.3 192.168.1.3 netmask 255.255.255.255 0 0

the new address is listed but the external ip address still points to the old internal address. I can't correct the problem until I reboot the PIX.

Is this some sort of a cache problem.

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: PIX 525 Ver. 6.3(1) & static IP problems

Martin,

Do you have a chance to implent the logical interface (virtual interface) ?

As you can see, 6.2(2) pix does not support virtual interface; however, 6.3(1) does. To answer your question, after you did the configuration, you must use

clear xlate command to clear all translations. I hope this would help you.

2 REPLIES
Community Member

Re: PIX 525 Ver. 6.3(1) & static IP problems

Martin,

Do you have a chance to implent the logical interface (virtual interface) ?

As you can see, 6.2(2) pix does not support virtual interface; however, 6.3(1) does. To answer your question, after you did the configuration, you must use

clear xlate command to clear all translations. I hope this would help you.

Community Member

Re: PIX 525 Ver. 6.3(1) & static IP problems

That did it, the "clear xlate" command worked, thanks for the help !!

129
Views
0
Helpful
2
Replies
СоздатьДля создания публикации, пожалуйста в систему