Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Pix 525

Hi,

I've a numerous ISDN users dialing to a Cisco1720 router which is connected to a Pix525 one of the ethernet port to access one of the zone secured by the Pix. I'm able to dial-in and get an IP address from the router but cannot access other zone, and I can only ping the Pix ethernet port that is connected to the Cisco1720.

P/S : I'm not familiar with Pix.

Thanks.

3 REPLIES
New Member

Re: Pix 525

Hello Carol,

There are a lot of things to think of.

1/ Which port of the pix is connected to the router (inside . outside, dmz)

2/ What traffic is allowed to pass through the pix (depend on the interface you use)

3/ Does the traffic need to be nat if it changed from interface

4/ Does the pix know the route back to the dial-in person

etc etc.

So please tell more about your configuration

Greetings,

Rene van Wolferen

New Member

Re: Pix 525

Hi Rene,

1/ The router is connected to the dmz port. (Pix firewall has 5 ports - 3 dmz, 1 outside, 1 inside)

Actually, Im not familiar with Pix, and that's why I'm not answering ur further question.

Can i email you the config ?

Thanks...

New Member

Re: Pix 525

Yes you can,

R.vanWolferen@wxs.nl

113
Views
0
Helpful
3
Replies
CreatePlease to create content