Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX 6.2, PPPoe, ADSL - VPN & E-mail/WWW routing.

I'm setting up a 506e to firewall an ADSL line into a company.

I've done this before with the VPN, and standard NAT, but when it comes to routing protocols to the inside, can I do it all on a single IP address from the ISP?

Looking at the config options, it looks like I have to have the ISP route me a subnet (At least a 252) to be able to do this.

The ADSL routing is going to be changed to bridging and the PIX is going to terminate the PPPoe.

Anyone done this before? Maybe a sample config?

-Mark

5 REPLIES
New Member

Re: PIX 6.2, PPPoe, ADSL - VPN & E-mail/WWW routing.

You should not have any issues with this type of deployment. Hereis a link that talks about the PPPoE config part of the PIX:

http://www.cisco.com/warp/customer/110/pppoe-for-pix501.html

As far as inbound access suck as www, smtp, etc., you will need a static translation defined for the inside hosts that will be accessed by the ouside hosts. This can be a port address tranlation or a host static translation. Then you can configure the access control for the inbound services (conduit or access-lists). Here is a link that discusses this part of the config.

http://www.cisco.com/warp/customer/707/28.html

I hope this addresses your questions unless you have a more specific issue.

Thanks,

Marcus

New Member

Re: PIX 6.2, PPPoe, ADSL - VPN & E-mail/WWW routing.

Can I do it all using the single IP from the ADSL ISP?

Or do I need to have them route me a subnet (...252) to do VPN and inbound WWW/SMTP?

-Mark

New Member

Re: PIX 6.2, PPPoe, ADSL - VPN & E-mail/WWW routing.

If the ISP assigns you a routable IP address that gets set on the outside interface of the PIX, you can use that single IP address for outbound PAT translations for outbound traffic and port redirection static statements for inbound access to services. So, yes, you can use that single address. For example:

global (outside) 1 interface

nat (inside) 1 192.168.1.0 255.255.255.0

static (insde, outside) tcp interface 80 192.168.1.100 80 netmask 255.255.255.255

static (insde, outside) tcp interface 8080 192.168.1.110 80 netmask 255.255.255.255

static (inside, outside) tcp interface 25 192.168.1.150 25 netmask 255.255.255.255

Hope this helps...

Marcus

New Member

Re: PIX 6.2, PPPoe, ADSL - VPN & E-mail/WWW routing.

Would this still be true if I was to use a VPN to VPN tunnel in the same config?

-Mark

New Member

Re: PIX 6.2, PPPoe, ADSL - VPN & E-mail/WWW routing.

Yes. You can also use the address to terminate a VPN tunnel, with both remote access clients and a LAN to LAN tunnel.

Thanks,

Marcus

316
Views
0
Helpful
5
Replies
CreatePlease to create content