Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Highlighted
New Member

Pix 6.3 with 2 interfaces and 2 ISP

I have a pix with 2 ISP on 2 outsides interface I know that I can only have one default route,

but with a different metric I can use it as a backup link or with a specific route I can use it.

My problem is that the backup link use a private address who overlap with my internal network and my question is

Is it possible to translate my inside source ip addresses and to balance traffic to both ISP with static route default or not ?

1 REPLY
Silver

Re: Pix 6.3 with 2 interfaces and 2 ISP

To the best of my knowledge, You can route the packet only using a single gateway as per in static routing. If you are using the dynamic routing, probably have using the metric you can play to load balance.

96
Views
0
Helpful
1
Replies
CreatePlease login to create content