01-09-2003 01:32 PM - edited 02-20-2020 10:28 PM
We are setting up a load balancing design, and I noticed the only routing protocol the Pix supports is RIP. I know in 6.3 it will support OSPF, what about EIGRP? Any information would be extremely helpful so i can anticipate design changes.
this is sort of what i am setting up.
http://www.cisco.com/en/US/tech/tk648/tk365/technologies_configuration_example09186a008009487d.shtml
Instead of routers, we are using dual 3550s EMI. and we have the 4 Port DMZ card. We are just using 1 unit though, with the failover unit. Using 1 port on the 4 port DMZ to as an incoming port. The outs go to the Load Balancers.
01-20-2003 07:25 AM
The PIX does not support EIGRP. The following gives an explanation for this. http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_61/config/subnets.htm
01-20-2003 07:42 AM
I know pix doesnt support EIGRP now, i was asking about version 6.3.
01-21-2003 05:11 PM
6.3 will support OSPF. no current plans for EIGRP support.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: