We are setting up a load balancing design, and I noticed the only routing protocol the Pix supports is RIP. I know in 6.3 it will support OSPF, what about EIGRP? Any information would be extremely helpful so i can anticipate design changes.
Instead of routers, we are using dual 3550s EMI. and we have the 4 Port DMZ card. We are just using 1 unit though, with the failover unit. Using 1 port on the 4 port DMZ to as an incoming port. The outs go to the Load Balancers.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...