Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX 7.0.4 and 7.0.4.5, "show xlate" reloads the pix.

Hi,

our customer has two 525 with Active/Standby failover.

This PIX are working as: L2L VPN concentrator (11 tunnels), remote access conectrator (2 users), local internet access (2MB line).

We have problems with "show xlate", every time we uses the command, the PIX reload without crashinfo file.

Has someone the same problem?

Thanks

1 REPLY
Silver

Re: PIX 7.0.4 and 7.0.4.5, "show xlate" reloads the pix.

The issue may be due to following reasons

PIX reboots with stack trace in isakmp_receiver thread (stress).

The Boothelper installation only supports PIX Firewall Version 5.1, 5.2, 5.3, 6.0, and later. After Boothelper downloads the PIX Firewall image via TFTP, it verifies the checksum of the image. If it is not Version 5.1 or later, it displays the message "Checksum verification on flash image failed" and reboots the PIX Firewall

105
Views
0
Helpful
1
Replies
CreatePlease to create content