PIX 7.0 show run to show IP addresses rather than names
I was wondering whether there is a way to tell the firewall to display the IP addresses of hosts and networks rather than the names that have been configured with the names command when I do a show run.
The obvious problem I have is when I want to edit the config or an access-list by copying it off the existing config, I have to then replace the names with IP addresses on every single line.
Re: PIX 7.0 show run to show IP addresses rather than names
Issue this command:
This leaves the name to IP configurations, but removes all references to the names from the configuration. Then, if you want to see the names instead of IP addresses again, simply issue the command "names" again.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...