09-26-2006 04:11 AM - edited 02-21-2020 01:11 AM
Hi,
I was wondering whether there is a way to tell the firewall to display the IP addresses of hosts and networks rather than the names that have been configured with the names command when I do a show run.
The obvious problem I have is when I want to edit the config or an access-list by copying it off the existing config, I have to then replace the names with IP addresses on every single line.
Anthony Hassiotis
09-30-2006 09:58 PM
Please refer to the usage of the 'names' syntax located at http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/no_711.htm#wp1646080
10-01-2006 03:23 PM
Issue this command:
no names
This leaves the name to IP configurations, but removes all references to the names from the configuration. Then, if you want to see the names instead of IP addresses again, simply issue the command "names" again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: