Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX 7.x INFO MESSAGE

I receive this messagge from my pix 525 7.1.2:

"INFO: Outside address overlap with static NAT configuration"

What is means?

4 REPLIES

Re: PIX 7.x INFO MESSAGE

It sounds like you have a static instruction and you are using a Public address which is probably already allocated to one of your interfaces. Please type a

show run | inc static and also show run | inc address and post it to have a quick look

New Member

Re: PIX 7.x INFO MESSAGE

I cleared all static configuration and added e simple example to test it, but the error message still here.

The strange thing is that only when i'm inserting a new network object in an object group the INFO message appear.

Why?

Using the command you gave to me i cannot see overlapping addresses ...

Inside 192.168.97.0/24

Outside 192.168.251.0/24

Dmz 192.168.249.0/24

I have a route on inside to 192.168.0.0/16 is this the problem?

New Member

Re: PIX 7.x INFO MESSAGE

I found that removing nat exemption access-list, the overlapping message go away.

I think i made some mistake on con figuring exemption and static nat, but i cannot find the solution.

Re: PIX 7.x INFO MESSAGE

If you like post the config and I will have a look

105
Views
0
Helpful
4
Replies
CreatePlease to create content