05-11-2003 09:19 PM - edited 02-20-2020 10:44 PM
Hi,
I have a setup in which my PIX 506 is connected to an 805 Router Via the
Ethernet port.I want to replace my 805 with a 1760 but the FastEthernet port
on the 1760 doesn't seem to inter-operate with the PIX ethernet Link.
Does this mean I have to go through another device(Switch)?
Scenario is as below.
LAN -> Switch - > PIX -> Router(805) -> ISP.
Thanks
05-12-2003 05:14 PM
THere shouldn't be any issues here. If you've set up both interfaces to auto-negotiate speed and duplex, and that's not working, try hard-coding them and see how that goes. Does the interface actually come up on the PIX and router? What does a "sho int" on both devices say (up/up or up/down)?
You can hard code the speed/duplex settings on the PIX with the following:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_62/cmdref/gl.htm#1026738
05-13-2003 11:41 AM
Hi,
are you using the right cable? I think in this case you should use a cross-over cable instead of a straight cable.
Is the interface on the router and on the pix enabled (on not administrative shutdown)?
Is the link speed and duplex mode ok?
Regards,
Tom
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide