05-17-2002 12:29 AM - edited 02-20-2020 10:04 PM
Hello,everyone:
I have a question : How many access-lists can apply to a pix interface? I know that a router interface can only apply one access-list to it in one direction(in or out).
05-17-2002 01:06 AM
You can only apply one access-list with access-group command to a particular interface. The access list is always applied in the "in" direction to the interface.
Router can have two IP access lists applied to the interface simultaneously - one "in" and one "out".
ROK
05-19-2002 05:59 PM
The doc said that access-list can replace conduit command .In the pix I can use many conduit command, If I can only use one access-list ,there will be not convenience? Because if I edit one item in the access-list, I should edit the whole access-list?
05-19-2002 11:13 PM
>The doc said that access-list can replace conduit command
It can.
>In the pix I can use many conduit command, If I can only use one
>access-list ,there will be not convenience? Because if I edit one item
>in the access-list, I should edit the whole access-list?
An access-list can have many rules (especially now w/ 6.2 and Turbo ACLs).
You can delete any line from access-list, but can only append to it, so, yes,
you can have situation where you replace entire ACL with different one (the
same procedure as in IOS routers - actually, PIX's ACLs behave like IOS
named ACLs).
ROK
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: