Have Secureclient on workstation inside network trying to access a Checkpoint firewall through a PIX 515. I authenticate to Checkpoint firewall, but then cannot hit protected website. I've opened outside access list to esp protocol and port 500. Get error message Pix-3-305006: Regular translation creation failed for protocol 50 src 220.127.116.11 dst 18.104.22.168. Anyone run across this?
Translation creation failed indicates a problem with the NAT static or global pool. Take a look at why the host is not getting a translation. If youre sure the configuration is correct, save your config to flash and reboot before you test again.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...