12-07-2001 02:38 AM - edited 02-20-2020 09:55 PM
Hi,
I have a pix506 setup working well now (thanks for the help!) but I have been requested to allow command line ftp out from client machines. Is there a special way of doing this?
Would I also need to create an access-list to allow ftp returns back in - I assume not??
Many thanks for your time.
cheers
Andy Goodwin
12-07-2001 07:51 AM
if you have not restricted "outbound" access using access-lists then all you would need is "fixup protocol ftp 21".
12-07-2001 07:52 AM
If you don't have a access control list on your inside interface, FTP should work fine. Make sure that 'fixup protocol ftp 21' is configured.
01-03-2002 05:47 AM
Can't understand why it wasn't working originally but it is now.
Thanks very much again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: