Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX and FTP

Hi,

I have a pix506 setup working well now (thanks for the help!) but I have been requested to allow command line ftp out from client machines. Is there a special way of doing this?

Would I also need to create an access-list to allow ftp returns back in - I assume not??

Many thanks for your time.

cheers

Andy Goodwin

3 REPLIES
New Member

Re: PIX and FTP

if you have not restricted "outbound" access using access-lists then all you would need is "fixup protocol ftp 21".

New Member

Re: PIX and FTP

If you don't have a access control list on your inside interface, FTP should work fine. Make sure that 'fixup protocol ftp 21' is configured.

New Member

Re: PIX and FTP

Can't understand why it wasn't working originally but it is now.

Thanks very much again.

224
Views
0
Helpful
3
Replies
CreatePlease to create content