Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX and SNMP

Hi,

we have a PIX 515E with 6.22 running. Does this software support SNMP v2 ? PIX doesn't doesn't reply back to SNMPv2 queries, however SNMPv1 works fine.

Also, is it possible to in PIX to get the number of hits for a particular ACL Rule ? E.g. Number of hits for an ACL rule that allows outside SMTP traffic.

Regards \\ Naman

1 REPLY
New Member

Re: PIX and SNMP

The PIX only uses SNMP v1. From the 6.3 docs:

"Use CiscoWorks for Windows or any other SNMP V1, MIB-II compliant browser to receive SNMP traps and browse an MIB. SNMP traps occur at UDP port 162"

In order to get the hits for an acess-list entry, you can type 'show access-list'. This will give you the number of hits on each entry of the access-list. Remember that a hit will only occur for packets that do not have an existing connection, i.e. packets for new connections will be the only packets that will register on the hit counter.

Hope this helps...

Marcus

112
Views
3
Helpful
1
Replies
CreatePlease login to create content