cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
563
Views
1
Helpful
1
Replies

PIX/ASA Failover conditions

Shobith K
Level 1
Level 1

I have a asa cluster in active/standby mode with lan cable connected for stateful failover. I want to know about the condtions when the box fails over to the other. One parameter should be the hello timers going between the failover interfaces.

Does this failover happen when the inside or outside interface of the primary asa goes down.

1 Reply 1

excession
Level 1
Level 1

What type of Firewall is it? What version.

For PIX 7.2 for example I would look at the configuration guide

http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/failover.html

In particular look at the section entitled "Failover Actions" for active/standby. These is a nice table of failover conditions there.

Similar for otehr PIX/FWSM/ASA

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: