Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX/ASA Failover conditions

I have a asa cluster in active/standby mode with lan cable connected for stateful failover. I want to know about the condtions when the box fails over to the other. One parameter should be the hello timers going between the failover interfaces.

Does this failover happen when the inside or outside interface of the primary asa goes down.

1 REPLY
New Member

Re: PIX/ASA Failover conditions

What type of Firewall is it? What version.

For PIX 7.2 for example I would look at the configuration guide

http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/failover.html

In particular look at the section entitled "Failover Actions" for active/standby. These is a nice table of failover conditions there.

Similar for otehr PIX/FWSM/ASA

338
Views
1
Helpful
1
Replies