I'm wondering if there is a way to configure a PIX to wait 5 or 10mins before booting up once there is power going into it. A customer I work with has a random power outages (at night) and when that happens, the firewall comes back up before the cable modem is fully up which screws up the DHCP process - basically the cable modem needs to be fully up first so when people get into the office in the morning, they don't have the internet until the firewall is rebooted. Both the firewall and the cable modem are on a UPS but I'm guessing that the outages are longer than the battery life of the UPS. Any ideas?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...