Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Pix Booting Problem

When i boot my PIX 501, it get stuck over

here

any clue

Regards manish

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

32 MB RAM

PCI Device Table.

Bus Dev Func VendID DevID Class Irq

00 00 00 8086 7192 Host Bridge

00 07 00 8086 7110 ISA Bridge

00 07 01 8086 7111 IDE Controller

00 07 02 8086 7112 Serial Bus 9

00 07 03 8086 7113 PCI Bridge

00 0D 00 8086 1209 Ethernet 11

00 0E 00 8086 1209 Ethernet 10

3 REPLIES
New Member

Re: Pix Booting Problem

Try to go to the monitor mode. Hit the 'esc' key when the pix boots.

if you are able to get there, you can use a tftp server to upgrade the code. Try to upgrade to the same code which is there on the pix.

the best way would be to open a TAC case.

Regards,

Sagar

New Member

Re: Pix Booting Problem

I have the same problem for PIX 525. When I hit the 'esc' key I get the test menue

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

256 MB RAM

Testing mode menu:

1. Test floating

2. Test protected mode.

3. Exhaustive Test first 640k.

4. Exhaustive Test high memory.

*. Start all tests (Any key to stop tests).

C. Continue.

I hope we could solve that also

New Member

Re: Pix Booting Problem

I was able to fix it,

What you need to do is open PIX Firewall Chassis,

Next to Bios Bettery, there is a jumper. Just change that jumper setting and it should start working

Regards

Thanks every one for there reply

Manish Young

349
Views
0
Helpful
3
Replies
CreatePlease to create content