cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6962
Views
0
Helpful
4
Replies

PIX command to show tunnel status up or down

Kevin Melton
Level 2
Level 2

I would like to ask if there is a specific command within the PIX OS that will allow me to show if the tunnels that I have set up for VPN from a remote PIX to the local one are active...

I have looked throught the show ? on the Pix but cannot determine...

You would think there would be a "show tunnel" command...

1 Accepted Solution

Accepted Solutions

ajagadee
Cisco Employee
Cisco Employee

Hi,

You can use:

" Show crypto isakmp sa " to see if your tunnel is up or not and,

"Show crypto ipsec sa" to see if the packets are getting encrypted/decrypted or not.

Regards,

Arul

View solution in original post

4 Replies 4

shabib.syed
Level 1
Level 1

show isakmp sa

This will show you all your vpn connections.

Thank You!

ajagadee
Cisco Employee
Cisco Employee

Hi,

You can use:

" Show crypto isakmp sa " to see if your tunnel is up or not and,

"Show crypto ipsec sa" to see if the packets are getting encrypted/decrypted or not.

Regards,

Arul

Thanks Arul!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: